Driverpatch for airoscript?

Live forum: http://rt2x00.serialmonkey.com/viewtopic.php?t=4483

Fvzzl3

03-12-2007 21:40:00

Hello,
i am a young student from Germany and have a problem with my system,
I am using the RT2500 and patched it with [url2b11pg4y]http://rt2x00.serialmonkey.com[/url2b11pg4y].
When i want to start the monitormodus for channel 7, i get this message back

[code2b11pg4y]
airmon-ng start wlan0 7


Interface Chipset Driver

wlan0 Ralink 2500 PCI rt2500pci - [phy0]/usr/local/sbin/airmon-ng: 833: cannot create /sys/class/ieee80211/phy0/add_iface: Permission denied
Error for wireless request "Set Mode" (8B06) :
SET failed on device mon0 ; No such device.
mon0: FEHLER beim Auslesen der Schnittstellenmerker: No such device

(monitor mode enabled on mon0)[/code2b11pg4y]

So iwconfig looks like this
[code2b11pg4y]
iwconfig

lo no wireless extensions.

eth0 no wireless extensions.

wmaster0 no wireless extensions.

wlan0 IEEE 802.11g Mode:Monitor Frequency:2.442 GHz
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

[/code2b11pg4y]

Should it not show like this
[code2b11pg4y]
lo no wireless extensions.

wifi0 no wireless extensions.

eth0 no wireless extensions.

wlan0 IEEE 802.11g ESSID:"" Nickname:""
Mode:Monitor Frequency:2.452 GHz Access Point: [local mac]
Bit Rate:0 kb/s Tx-Power:18 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/94 Signal level=-95 dBm Noise level=-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0[/code2b11pg4y]



The monitormode is activated but it is not able to run this code here

[code2b11pg4y]
aireplay-ng -1 0 -e fortknox -a 00:18:4D:37:D4:76 -h 00:11:09:22:60:0E wlan0

The interface MAC (00:13:D3:84:3E:22) doesn't match the specified MAC (-h).
ifconfig wlan0 hw ether 00:11:09:22:60:0E
22:35:37 Waiting for beacon frame (BSSID: 00:18:4D:37:D4:76)
22:35:37 Sending Authentication Request
22:35:39 Sending Authentication Request
22:35:41 Sending Authentication Request
22:35:43 Sending Authentication Request
22:35:45 Sending Authentication Request
22:35:47 Sending Authentication Request
22:35:49 Sending Authentication Request

Attack was unsuccessful. Possible reasons:

* Perhaps MAC address filtering is enabled.
* Check that the BSSID (-a option) is correct.
* Try to change the number of packets (-o option).
* The driver hasn't been patched for injection.
* This attack sometimes fails against some APs.
* The card is not on the same channel as the AP.
* Injection is not supported AT ALL on HermesI,
Centrino, ndiswrapper and a few others chipsets.
* You're too far from the AP. Get closer, or lower
the transmit rate (iwconfig <iface> rate 1M).
[/code2b11pg4y]

Can someone help me?
Should i patch the driver?
?-> http//patches.aircrack-ng.org/

Note Sorry for my bad english

Fvzzl3

05-12-2007 14:05:19

I found out that there is a problem with the injection_test.
It failed.

Spy84464

06-12-2007 12:42:26

Hello,
Last time I tried, there was no problem with injection, no patch is required. Are you using a recent CVS tarball? Did you enable injection "iwpriv ra0 rfmontx 1"?

Regards,
Romain

Fvzzl3

06-12-2007 20:12:21

"iwpriv ra0 rfmontx 1"?[/quote25wq6fsb]

ra0 no private ioctls

Spy84464

07-12-2007 21:35:33

I overlooked your first post, you are actually using rt2x00 (rt2500[b31wxf0wo]pci[/b31wxf0wo]), our new driver, not rt2500 (without pci).
rt2x00 doesn't support injection yet. Blacklist it and install the legacy driver. Make sure the following modules are never loaded at the same time
rt2500pci (rt2x00) and rt2500 (legacy driver).

Fvzzl3

09-12-2007 09:09:00

I overlooked your first post, you are actually using rt2x00 (rt2500[b3t8027mw]pci[/b3t8027mw]), our new driver, not rt2500 (without pci).
rt2x00 doesn't support injection yet. Blacklist it and install the legacy driver. Make sure the following modules are never loaded at the same time
rt2500pci (rt2x00) and rt2500 (legacy driver).[/quote3t8027mw]

So is that this driver?
http//prdownloads.sourceforge.net/rt24 ... z?download

Or this?
http//rt2x00.serialmonkey.com/rt2570-cvs-daily.tar.gz

Spy84464

10-12-2007 18:47:23

Neither, these drivers are for rt25[b3l8itk3w]70[/b3l8itk3w], not rt25[b3l8itk3w]00[/b3l8itk3w]. Use this one [url3l8itk3w]http://rt2x00.serialmonkey.com/rt2500-cvs-daily.tar.gz[/url3l8itk3w].