with old driver
root@localhost:/home/darwin# modprobe rt2500
root@localhost:/home/darwin# dmesg | tail
NET: Registered protocol family 4
NET: Registered protocol family 3
NET: Registered protocol family 5
rt2500 1.1.0 BETA4 2006/06/18
http://rt2x00.serialmonkey.comrt2500 EEPROM: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Channel
rt2500 EEPROM: 2 2 2 2 2 2 3 3 3 3 3 3 3 3 dBm Maximum
ra0: no IPv6 routers present
root@localhost:/home/darwin# ifconfig ra0 up
root@localhost:/home/darwin# iwlist ra0 scan
ra0 Scan completed :
Cell 01 - Address: 00:14:6C:D2:25:D2
Mode:Managed
ESSID:"SHIMATA"
Encryption key:off
Channel:1
Quality:50/100 Signal level:-93 dBm Noise level:51 dBm
with new driver
root@localhost:/home/darwin# modprobe rt2500
root@localhost:/home/darwin# dmesg | tail
rt2500 EEPROM: 2 2 2 2 2 2 3 3 3 3 3 3 3 3 dBm Maximum
ra0: no IPv6 routers present
ACPI: PCI interrupt for device 0000:01:09.0 disabled
PCI: Enabling device 0000:01:09.0 (0110 -> 0112)
ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [LNKB] -> GSI 19 (level, low) -> IRQ 233
rt2500: 1.1.0 CVS 2009022815
http://rt2x00.serialmonkey.comroot@localhost:/home/darwin# ifconfig ra0 up
root@localhost:/home/darwin# iwlist ra0 scan
ra0 No scan results