rt2x00.serialmonkey.com • View topic - How do I install the Git files into the kernel?

View unanswered posts | View active topics

Board index » General » Other Discussion

All times are UTC

How do I install the Git files into the kernel?

Moderators: serialmonkey, lfcorreia, gwingerde, IvD

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

manixdk

Post subject: How do I install the Git files into the kernel?

Posted: Mon Jan 21, 2008 8:59 pm

Joined: Wed Jan 16, 2008 7:16 pm
Posts: 2

I've installed GIT, following the instructions at http://rt2x00.serialmonkey.com/wiki/ind ... structions.

How do I now install the files into the kernel? I manned GIT, and searched the Internet, but it's complete gobbledygook (sort snak as we say in Danish).

I need someone to hold my hand (-:, as I am very green when it comes to hard-core bit-banging.

Top

IvD

Post subject:

Posted: Mon Jan 21, 2008 9:56 pm

Site Admin

Joined: Sun Jun 05, 2005 1:01 pm
Posts: 5905
Location: Haarlem, The Netherlands

When you downloaded the git repository, you have the kernel sources.
You need to follow the Kernel compilation howtos found online and make sure you enable mac80211 and rt2x00 in the configuration.
After that just boot into your freshly baked kernel.

_________________
Regards,
Ivo van Doorn
Project Administrator
http://rt2x00.serialmonkey.com

Top

Page 1 of 1

[ 2 posts ]

Board index » General » Other Discussion

All times are UTC

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum